Filter
Top Products
Synchronizing the transmitter with the EK 2000 IEM receiver
30
Synchronizing the transmitter with the EK 2000 IEM
receiver
When synchronizing your transmitter with the EK 2000 IEM receiver, please observe the
following:
Synchronizing the transmitter with an EK 2000 IEM receiver –
individual operation
Upon delivery, transmitter and receiver are synchronized with each other. If, however, you
cannot establish a transmission link between transmitter and receiver, you have to
synchronize the channels of the devices:
̈ First carry out the Easy Setup Sync function (see table on page 16, left-hand column).
The transmitter is set to a suitable frequency.
̈ Then carry out the Sync function (see table on page 16, right-hand column).
This establishes a transmission link between the transmitter and the receiver.
Alternatively, you can set the channel on the transmitter manually:
̈ Make sure that you set the transmitter to the same frequency bank and the same channel
as the receiver.
Synchronizing transmitters with EK 2000 IEM receivers – multi-
channel operation
Network operation In multi-channel operation, the transmitters are remote controlled via a PC running the
“Wireless Systems Manager” (WSM) software.
̈ Connect your transmitters and your PC in a network (see page 12).
̈ Switch your transmitters and your PC on.
̈ Launch the “Wireless Systems Manager” (WSM) software.
̈ To set up your multi-channel system, proceed as described in the instruction manual of
the “Wireless Systems Manager” (WSM) software.
̈ Only use a transmitter and a receiver from the same frequency range (see the
type plates on the transmitter and the receiver).
̈ Make sure that the desired frequencies are listed in the enclosed frequency
information sheet. You can also contact your Sennheiser partner who will be
pleased to calculate intermodulation-free frequencies for you.
̈ Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
̈ The frequency information sheet can also be downloaded from the corresponding
product page on our website at www.sennheiser.com.
Advantages of controlling the transmitters via the “Wireless Systems Manager”
(WSM) software:
• Detailed overview of all transmission and receiving channels
• Remote control of all transmitters in the network
• Combination of transmitters of different frequency ranges (see page 4).
Stereo Transmitter SR 2050 IEM
Stereo Transmitter SR 2050 IEM
Stereo Transmitter SR 2050 IEM