Filter
Top Products
Adjusting settings via the operating menu
25
To change the treble and bass of the audio output signal, proceed as follows:
Activating/deactivating the automatic lock mode – “Auto Lock”
The lock mode prevents that the plug-on transmitter is accidentally switched off or
programed during operation. The lock mode icon on the standard display indicates that
the lock mode is activated. For information on how to use the lock mode, refer to page 14.
The extended menu “Advanced Menu”
Setting the transmission frequencies and the frequency banks “U1” to “U6” –
“Tune”
300 Hz - 1 kHz
1 - 3 kHz
3 - 10 kHz
̈ Turn the jog dial to boost or cut the frequency range.
̈ Press the jog dial to change to the next frequency range or to store the complete
entry.
Display Frequency range
Sensitivity
Mode
Easy Setup
Frequency Preset
Name
Equalizer
Auto Lock
Advanced
Exit
Menu
̈ Turn the jog dial to select the desired setting.
Auto Lock
– 18 dB
Select the desired
setting
Auto Lock
Store the setting
Menu
Inactive
Inactive
Call up “Auto Lock”
Equalizer
Auto Lock
Advanced
“Stored”
PEAKPEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
PEAKPEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
PEAKPEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
Active
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
When you have selected one of the system banks and then select the “Tune” menu,
the transmitter automatically switches to channel 1 of the frequency bank “U1”. In
this case, “U1.1” briefly appears on the display panel.
Upon delivery, the channels of the frequency banks “U1” to “U6” are not assigned a
transmission frequency.
When you are in the “Tune” menu item, the RF signal is deactivated.