Filter
Top Products
Using the transmitter
16
When carrying out the Sync function, the transmitter’s current frequency bank and
channel setting as well as the receiver parameters adjusted via the “Sync Settings”
submenu (see page 27) are transferred to the EK 2000 IEM receiver via the infra-red
interface.
Carrying out an Easy Setup Sync or a Sync function
The following assumes that you are using the Easy Setup Sync function for setting up a multi-
channel system. You can also use the Easy Setup Sync function for establishing a
transmission link between one transmitter and one
EK 2000 IEM
receiver.
Easy Setup Sync Sync
̈ Switch all transmitters and one receiver
on.
̈ Switch the transmitter and the receiver
on.
̈ On all transmitters, call up the “Easy
Setup” menu item.
The text “Easy Setup Sync” and the
icon appear on the display panels of the
transmitters.
The RF signal of the transmitters is
automatically deactivated.
̈ Press the button ¿ on the
transmitter.
The icon appears on the display
panel of the transmitter.
̈ Use your receiver to perform a frequency
preset scan (Scan New List).
̈ Select a channel within a frequency bank
with a sufficient number of unused
channels (Current List).
–
̈ Place the infra-red interface of the
receiver (see the instruction manual of
the receiver) in front of the infra-red
interface ´ of the first transmitter.
̈ Place the infra-red interface of the
receiver (see the instruction manual of
the receiver) in front of the infra-red
interface ´ of your transmitter.
OFF
2
4
6
PHONES
´
OFF
2
4
6
PHONES
ᕥ
ᕤ