Filter
Top Products
8
Using the plug-on transmitter
Using the plug-on transmitter
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see the instruction manual of the
receiver).
2. Switch the plug-on transmitter on (see below).
The transmission link is established and the diversity receiver’s RF level
display “RF” reacts.
Switching the plug-on transmitter on/off
To switch the plug-on transmitter on (online operation):
To switch the plug-on transmitter off:
̈ If necessary, deactivate the lock mode (see page 9).
To switch the plug-on transmitter on and to deactivate the RF signal on
switch-on (offline operation):
To activate the RF signal:
̈ Press the ON/OFF button º.
The plug-on transmitter transmits an RF signal. The red
ON LED ¶ lights up and the standard display “Frequency/
Name” appears on the display panel. The transmission icon ብ
is displayed.
You can switch the plug-on transmitter on and deactivate the
RF signal on switch-on. For more information, see below.
̈ Press the ON/OFF button º until “OFF” appears on the
display panel.
The red ON LED ¶ goes off and the display panel turns off.
When in the operating menu, pressing the ON/OFF button º will
cancel your entry (ESC function) and return you to the current
standard display.
̈ Press the SET button until “RF Mute On?” appears on the
display panel.
̈ Press the SET button.
The transmission frequency is displayed but the plug-on
transmitter does not transmit an RF signal. The transmission
icon ብ is not displayed.
Use this function to save battery power or to prepare a plug-on
transmitter for use during live operation without causing inter-
ference to existing transmission links.
̈ Press the ON/OFF button.
“RF Mute Off” appears on the display panel.
̈ Press the SET button.
The transmission icon ብ is displayed again.
¶
º
ON/OFF
ON/OFF
SET
SET
MHz
533.875
ew100 G3
MUTE
P
AF
ብ
ON/OFF
SET
SKP100_529675_0409_Sp9.book Seite 8 Donnerstag, 9. April 2009 1:48 13