Filter
Top Products
7
Putting the plug-on transmitter into operation
Putting the plug-on transmitter into
operation
Inserting the batteries/accupack
For powering the plug-on transmitter, you can either use two 1.5 V AA size
batteries or the rechargeable Sennheiser BA 2015 accupack.
̈ Slide the battery compartment cover ¸ in the direction of the
embossed arrow and open the cover ¸.
̈ Insert the two batteries or the accupack as shown below. Please
observe correct polarity when inserting the batteries/accupack.
̈ Close the battery compartment.
The battery compartment cover ¸ locks into place with an audible
click.
Charging the accupack
̈ Remove the BA 2015 accupack (optional accessory).
̈ Insert the BA 2015 accupack into the L 2015 charger (accupack and
charger are optional accessories):
Plugging the plug-on transmitter onto a microphone
̈ Plug the microphone’s XLR-3M socket onto the transmitter’s XLR-3F
socket ³.
̈ Tighten the locking ring · in the direction of the arrow.
The L 2015 charger can only charge the BA 2015 accupack. Stan-
dard batteries (primary cells) or individual rechargeable battery
cells cannot be charged.
The transmitter uses the microphone body as an antenna – there-
fore microphones with a metal casing should be used for best
signal transmission.
¸
¸
·
³
SKP100_529675_0409_Sp9.book Seite 7 Donnerstag, 9. April 2009 1:48 13