Filter
Top Products
24
Adjusting settings via the operating menu
The extended menu “Advanced Menu”
Setting transmission frequencies and frequency banks –
“Tune”
Via the “Tune” menu item, you can set a transmission
frequency to be stored in the current channel or you can
select a different channel in one of the frequency banks
“U1” to “U6” and assign this channel a transmission
frequency.
Setting a transmission frequency for the current channel
̈ Set the desired frequency.
Selecting a frequency bank and a channel and assigning
this channel a frequency
When you have selected one of the system banks
and then select the “Tune” menu, the bodypack
transmitter automatically switches to channel 1 of
the frequency bank “U1”. In this case, “U1.1” briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks
“U1” to “U6” are not assigned a transmission
frequency.
When you are in the “Tune” menu item, the RF
signal is deactivated.
It is vital to observe the notes on frequency
selection on page 28.
̈ Press the rocker button until the “Tune” menu
item appears.
̈ Press the SET button.
The frequency selection appears.
̈ Press the SET button.
Your settings are stored.
You are back to the operating menu.
̈ Press the rocker button until the “Tune” menu
item appears.
̈ Keep the SET button pressed until the frequency
bank selection appears.
Select the MHz
value and confirm
Select the kHz
value; store the
setting
542.625 MHz
Tune
544.625 MHz
B.Ch: U1. 1 B.Ch: U1. 1
Tune
Call up “Tune”
Advanced
Menu
Tune
“Stored”
542.625 MHz
SET SET
SET