Sennheiser SK 500 G3 Satellite Radio User Manual


 
15
Using the bodypack transmitter
̈ From the “Mute Mode” menu item, select the desired
setting (see page 25).
̈ Exit the operating menu.
̈ Slide the MUTE switch MUTE · to the left, to the
position MUTE.
The bodypack transmitter reacts as indicated in the
table.
The current state of the muting function or the RF signal is
displayed on the display panel of the bodypack transmitter.
An additional display of the muting function
appears on the receiver’s display panel when
the pilot tone function is activated on both
bodypack transmitter and receiver
and, in addition,
this display has been activated via the
Warnings” menu item on the receiver (see the
instruction manual of the receiver).
Audio signal is muted
Transmitter’s display panel: MUTE is displayed
Receiver’s display panel: TX Mute” is displayed*
* only when activated on the receiver (see previous
section)
Audio signal is activated (muting is deactivated)
Transmitter’s display panel: MUTE is not displayed
Receiver’s display panel: TX Mute” is not displayed
RF signal is deactivated
Transmitter’s display panel: transmission icon is not
displayed,
MUTE is displayed
Receiver’s display panel: RF Mute” is displayed*
* only when activated on the receiver (see previous
section)
RF signal is activated
Transmitter’s display panel: Transmission icon is
displayed,
MUTE is not displayed
Receiver’s display panel: RF Mute” is not displayed
MHz
542.625
ew500 G3
MUTE
P
AF