Filter
Top Products
Putting the PXC 360 BT into operation
14
Pairing the PXC 360 BT with your audio source
When switching the headphones on for the first time, they will automati-
cally go into pairing mode. The headphones are waiting to be paired with
a Bluetooth enabled device (see page 13).
̈ Press the Master button ቦ and keep it pressed until the LED ቢ
alternately flashes blue and red.
̈ On your audio source, activate the Bluetooth function “Add a new
device”.
̈ Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identi-
fication information. The LED ቢ flashes 3 times blue and you hear an
ascending beep. The devices have identified each other and the head-
phones are paired with the audio source.
If a connection is established, the LED ቢ continues to slowly flash blue.
If no device is found within approx. 5 minutes, the LED ቢ flashes
3 times red and you hear a descending beep. The headphones will then try
for 3 minutes to connect to one of the up to 8 previously paired audio
sources. If this fails, the headphones automatically switch off after
60 minutes.
̈ In this case, repeat the necessary steps to pair the headphones with
your audio source again.
Switching the “Bluetooth connection” flashing on/off
̈ Switch the headphones off (see “Switching the PXC 360 BT on/off” on
page 12).
To switch the flashing on during a Bluetooth connection:
̈ Press the Master button ቦ and keep it pressed until the LED ቢ
alternately flashes blue and red.
̈ Briefly press the Volume button ቧ.
To switch the flashing off during a Bluetooth connection:
̈ Briefly press the Volume button ቤ.
̈ Make sure that your headphones are switched off (see
“Switching the PXC 360 BT on/off” on page 12).
5
1
1
PIN code
When the audio source prompts for a password or PIN code, enter
the default PIN code “0000”.
1
3s
1
5
1
3
6