Filter
Top Products
Adjustment tips for the operating menu
40
Setting a receiver to standby mode
You can set a receiver to standby mode and mute it. To do so, proceed as
follows:
̈ Change to the setting mode of the “Standby” menu.
The icon and the green backlighting of the save button 8 flash.
̈ Press the save button 8.
The esc button 6 is backlit in red. The receiver is set to standby mode
and the display is switched off.
To end the standby mode:
̈ Press the jog dial 7 or the esc button 6.
The display is switched on.
Loading the factory-preset default settings
Via the “Reset” menu, you can reset the current settings to the factory-
preset default settings.
̈ Change to the setting mode of the “Reset” menu.
The query “Reset to factory defaults?” appears. The green backlighting
of the save button 8 flashes.
̈ Press the save button 8 until the progress bar is complete.
All settings except for the booster supply voltage, the sampling rate at
the digital output and the network address are reset to the factory-
preset default settings. The display changes to the selection mode of
the operating menu.
Standby
OFF
Res
e
000
M
AC
0
1B
6
00
0
01
OFF
esc
save
sync
digital audio
processing
sync
DEV
M
H
z
800.450
03.03
BANK
CH
COM
AF
The standby mode remains active even when you switch the
receiver off and on again.
Reset
000
a
ndb
y
OFF
000
Reset to
factory defaults ?
esc
save
sync
digital audio
processing
sync
DEV
M
H
z
776.000
01.01
BANK
CH
COM
AF