Filter
Top Products
Product overview
12
Command display (status display of the audio outputs AF and
Command)
The command display is only available with the EM 3732-II COM twin
receiver.
Besides the two audio outputs K and M the EM 3732-II COM twin receiver
also features the two command outputs J and L.
Via the “Command” menu, you can configure the receiver so that – with
the command button of the transmitter pressed – the audio signal is
available at only one of the outputs or at both (see “Configuring the audio
outputs of the EM 3732-II COM” on page 34).
The command display ¾ shows the audio output at which the
transmitter’s audio signal is available.
When “AF” lights up brightly, the audio signal is available at the audio
output K and/or M.
When “AF” does not appear, the audio signal is not issued on the audio
output K and/or M.
When “COM” lights up brightly, the audio signal is available at the
command output J and/or L.
When “COM” does not appear, the audio signal is not issued on the
command output J and/or L.
LEDs for booster supply of antenna inputs
The LEDs for booster supply of antenna input A N and/or B S light up
when:
• the booster supply voltage is applied to the corresponding antenna
input A O and/or B R.
The LEDs for booster supply of antenna input A N and/or B S go off
when:
• the booster supply voltage for the corresponding antenna input A O
and/or B R is switched off or
• the booster supply voltage is short-circuited or overloaded.
COM
AF
JK
LM
AF
COM
N
OP
Q
R
S