Filter
Top Products
66
ቢባ
24 Sennheiser transmitters report their battery status
Sennheiser supplies hand-held and pocket transmitters which provide information on the available
transmitter battery status to the receiver. This information can be evaluated with the EM 3532
receiver.
ቢ The remaining battery capacity is first indicated via the six-step bargraph on the display
panel ᕣ.
ባ When the battery capacity is so low that only a transmission time of about 20 to 30 minutes
remains, the “LOW BATT” display flashes on the display panel ᕣ.
You should now immediately replace the transmitter battery. The AMF (
Advanced Muting
Function) in the EM 3532 receiver helps you, as far as possible, to maintain the transmission
without noise.
Notes
Ǡ The “LOW BATT” display is reset by the mute function. Whenever the squelch is activated
in the receiver, the “
LOW BATT” display goes off and the evaluation of the battery status
signal from the transmitter starts over again.
Ǡ Under favourable reception conditions, the evaluation of the battery information from the
transmitter lasts about 10 – 20 seconds. However, it can be significantly longer if reception
is subject to interference from time to time. This time is then also needed by the display in
display panel
ᕣ in order to update the information shown.