Filter
Top Products
60
18 Adding a supply voltage for antenna boosters
Antenna boosters can be connected to the antenna inputs of the EM 3532 receiver and can be
supplied by the receiver via the antenna cables. The supply voltage can be switched on or off. Both
receivers in the EM 3532 should be set to the same setting, i.e. both receiver should be set to either
“
On” or “OFF”!
Ǡ Press the ̃/̅ buttons to select the “BOOSTER FEED” menu. The current setting – i.e. “On”
or “OFF” – is indicated on the display.
Then press the
SET button. The “BOOSTER FEED” display on the display panel begins to
flash.
You can now select your desired setting:
Ǡ Press the ̅ button to switch on the booster supply voltage, “On” appears on the display:
Ǡ Press the ̃ button to switch off the booster supply voltage, “OFF” appears on the display:
Ǡ Your setting has to be stored before it becomes effective. To store a setting, press the SET
button until “Sto” briefly appears on the display, indicating that your setting has been
stored. The display then switches back to the standard display.
If the booster supply voltage is switched on, the “BOOSTER FEED” display on the display
panel is lit up.
You can discontinue the programming of this menu at any time by briefly (!) pressing the
SET button. The previous setting is then kept. If you do not press any of the three
programming buttons for more than 30 seconds, the setting mode is automatically left and
the previous setting is also kept.