Filter
Top Products
62
20 Remote control
The EM 3532 receiver can be set for “computer remote control only”. When set for remote control,
all other menus – except for “
REMOTE” – are locked. If you try to select any other menu, “Loc”
appears on the display.
Ǡ Press the ̃/̅ buttons to select the “REMOTE” menu. The current setting – i.e. “On” or
“OFF” – is indicated on the display.
Then press the
SET button. The “REMOTE” display on the display panel begins to flash.
You can now select your desired setting:
Ǡ Press the ̅ button to switch on the remote control, “On” appears on the display:
Ǡ Press the ̃ button to switch off the remote control, “OFF” appears on the display:
Ǡ Your setting has to be stored before it becomes effective. To store a setting, press the SET
button until “Sto” briefly appears on the display, indicating that your setting has been
stored. The display then switches back to the standard display.
If the receiver is set to remote control, the “REMOTE” display on the display panel is lit up.
You can discontinue the programming of this menu at any time by briefly (!) pressing the
SET button. The previous setting is then kept. If you do not press any of the three
programming buttons for more than 30 seconds, the setting mode is automatically left and
the previous setting is also kept.