Filter
Top Products
23
ENG
CONNECTIONS
Place the wireless receiver module at the rear of the listening position. If the wireless
receiver module is too close to the main unit, some sound interruption may be heard due
to interference.
If you use a device such as a microwave oven, wireless LAN Card or any other device that
uses the same frequency (5.8GHz) near the system, some sound interruption may be
heard due to interference.
The transmission distance from the main unit to the wireless receiving module is about
10m, but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the main unit and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
If the main unit doesn't make wireless connection, the system needs ID Setting between
main unit and wireless receiver module. With the main unit turned off, press the remote
control's number button buttons "0"J"1"J"3"J"5" and the main unit will turn on. With the
wireless receiver module turned on, press "ID SET" button on the back of the unit for
5 seconds.
M
Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be
removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the Blu-ray Home Theater is turned off. Inserting the card when it
is turned on may cause a problem.
If the TX Card is inserted and wireless receiving module setting is complete, sound is not
output from the Rear Speaker connectors on the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit
away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver
module location is clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1
channel or Dolby Pro Logic II .
In 2-CH mode, no sound will be heard from the wireless rear speakers.
Wireless Receiving Module (SWA-4000)
Connect the front, center and Subwoofer speakers to the
Blu-ray Home Theater, referring to page 23.
With the Blu-ray Home Theater turned off, insert the TX card
into the TX Card Connection(WIRELESS) on the back
of the main unit.
Hold the TX card so that the slanted side faces to the left
and insert the card into the port.
The TX card enables communication between the main
unit and the wireless receiver.
Connect the left and right rear speakers to the wireless
receiving module.
Plug the power cord of the wireless receiving module
in the wall outlet.
Turn on the
Blu-ray Home Theater
. The main unit and wireless module will now communicate with
each other and you will hear sound from the rear speakers.
1.
2.
•
•
3.
4.
5.
Slanted side face left
TX card
HT-BD1250A_XAC_0804-1.indd 23HT-BD1250A_XAC_0804-1.indd 23 2009-08-05 4:11:392009-08-05 4:11:39