Filter
Top Products
19
NOTE: The CAV6.6 and UNO-S2 firmware must be version 2.00.01 or high-
er to control the ST2 Tuner. Use the System Info menu of the CAV6.6 to
check the firmware version. If the firmware is not version 2.00.01, go to
the Document Center at www.russound.com
to obtain the latest version.
To Program the CAV6.6 to operate with the ST2 Tuner:
When the ST2 Tuner is used with the CAV6.6 or other RNET controller, it is configured as an RNET
command type “Peripheral” and is connected via the RNET bus. This makes the tuner behave as a
fully integrated device with UNO-S2 keypad support. Each tuner can be set up with a unique source
number 1 - 6 or unassigned. An unassigned tuner is not controlled by the RNET bus.
Key Function Note: When using the tuner with the CAV6.6-S2 system, do not reassign keypad and
remote buttons for tuner control in the CAV6.6 Key Configuration Menu. When the tuner is assigned
the “Peripheral” command type in the CAV6.6 Setup Menu, key assignments and functions are auto-
matically assigned and will operate as shown in the preceding UNO-S2 keypad and UNO-LRC1 remote
diagrams.
CAV6.6 Installation Menu:
SOURCE SETUP
Source Setup allows the system’s sources to be configured.
BASIC SETUP
This procedure uses built-in source “templates” to quickly and easily configure the source settings
needed for basic operation of the source component. Before performing BASIC SETUP, connect the
source components to the receiver/amp and be sure that all sources are powered on.
1. SOURCE NUM – Select the source number to which Tuner 1 is connected.
2. SOURCE NAME – Select the name for the source (e.g., Tuner 1 or Tuner 2).
3. COMMAND TYPE – Select PERIPHERAL.
4. SAVE CHANGES? – Select “Yes” to save changes. Procedure returns to SOURCE
NUM to allow configuration of the second tuner.
ST2 TUNER PROGRAMMING
PROGRAMMING FOR CAV6.6 USE