Filter
Top Products
15
ST2 OPERATION
UNO-S2 KEYPAD CONTROLS WITH CAV6.6
CAV6.6-UNO-S2 Keypad Operation
NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the CAV6.6 programming
steps (see page 19)
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-S2 keypad will
bring the tuner out of standby mode.
Selecting the desired tuner
On the UNO-S2 keypad, press to select either
Tuner 1 or Tuner 2 by choosing the tuner’s
preassigned source number.
Selecting the desired band
Push to toggle between AM band and FM band
reception.
Selecting the desired frequency
Use and for manual tuning. The frequen-
cy will appear on the keypad and the active tuner. To
move quickly through the channels, press and hold
either or for more than 1.5 seconds.
Frequency Seek
A press on will seek the next higher tuneable
station. If a tuneable station is not found, end the
SEEK function by pressing again.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up or
for bank down. The bank’s
name will be temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press and to scroll through the memory
presets for the selected bank. This procedure will
step through all of the presets in the current bank,
then loop back to start at the first one. Only config-
ured presets will be displayed.
Mute
Press to mute/unmute the tuner audio output.