Filter
Top Products
17
UNO-LRC1 Remote Control
Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-LRC1 will bring
the tuner out of standby mode.
Selecting the desired tuner
To select a tuner, push and choose the source
number preassigned to Tuner 1 or Tuner 2, or use the
numeric source inputs at the bottom of the
UNO-LRC1.
Selecting the desired band
Push to toggle between AM band and FM band
reception.
Selecting the desired frequency
Use the Channel and for manual tuning.
To move quickly through the channels, press and hold
either of the Channel buttons for more than 1.5 sec-
onds. The Select and can be used in
the same manner.
To directly select a station, press the three- or four-
digit station frequency (1071 for 107.1, etc.).
European regions use five-digit station frequencies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select or . To seek higher
frequency station press Select , and press
Select for lower frequencies. Select tuning
begins at the current frequency, seeks upward and
stops at the next tuned station. Pushing the Select
again continues the SEEK function. Once the
highest frequency is reached, the tuner continues in
SEEK mode at the lowest frequency.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down. The bank’s name will be
temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press the and to scroll through the
memory presets for the selected bank. This proce-
dure will step through all of the presets in the current
bank, then loop back to start at the first one. Only
configured presets will be displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
ST2 OPERATION
UNO-LRC1 REMOTE CONTROL WITH CAV6.6