Filter
Top Products
Battery Installation
Ensure that the On/Off volume control knob is turn
off. Press down and hold down the battery release latch, slide
the battery pack about 1/8 inch back, toward the latch, until it
stops. Then lift battery pack out. Replace batteries as follows:
WARNING: Do not place an alkaline battery pack in any bat-
tery charger. Severe charger and battery pack damage may
result.
7-2
1. Open the battery pack by inserting
finger nail and lifting.
2. Pull battery strap to remove low
or dead batteries.
3. Load new batteries following the
polarity as shown in battery case.
5. Be sure strap goes under batteries.
6. Tuck end of strap under door when placing the
battery cover back on the case.
4. Start loading at the end of the case where
the strap is attached to the case.
Figure 7-2
Battery Installation