Filter
Top Products
RKP-4 Operation
Basic Operational Description
The RKP-4 is the beltpack for the RKP-4 keypanel system.
The wireless system is a full duplex (simultaneous talk and lis-
ten) audio system that is designed to work with Adam,
Adam CS and Zeus and CRONUS Digital Matrix
Intercom System. The RKP-4’s operation is very similar to the
MKP-4, TKP-4, and WKP-4, four button wired keypanels.
The beltpack, via the base station, allows communications
with a Digital Matrix and acts as a keypanel on the system.
The base has the ability to program the frequencies of the
beltpack over-the-air. The sidetone for the base’s local head-
set and the beltpack are adjusted at the base station.
System Quick Start
The following is a list to quickly get a base station and
beltpack operating.
1. Plug the base station into the desired Matrix port.
2. Press <MENU> as powering up the base station.
3. Set the Matrix address and options via the software
menu. Reach the parameters to set by pressing
<MENU>, then select, “System Settings”, now select
“Matrix Settings”.
4. Press <MENU> as powering-up the beltpack.
5. Press <MENU> on the beltpack until you arrive at the
encryption code screen. Press <SET> to begin editing
the 4-digit code. Set the code that you wish.
6. When finished with the encryption code, press and
hold <MENU> + <UP> for 3 seconds on the beltpack.
Then set the 4-digit base serial number on the belt-
pack’s display.
7. At the base station, set the 4-digit encryption code to
match the beltpack.
8. The base should now indicate, on the main status
screen, a battery voltage and signal strength indicating
the base and beltpack are communicating.
9. The beltpack should now indicate dashes on the
CWW. This indicates it is communicating with the
matrix.
10. Plug a headset into the base and beltpack. Adjust the
microphone gain on both so the overmodulation light
flashes only on the loudest expected speech level.
7-1
Section
7
RKP-4 Operation