Filter
Top Products
Basic Operational Description
The RKP-4B is the base station for the RKP-4 beltpack. The
wireless keypanel system is a full duplex (simultaneous talk
and listen) audio system that is designed to work with
Adam, Adam CS and Zeus and CRONUS Digital
Matrix Intercom Systems. The RKP-4’s operation is very sim-
ilar to the MKP-4, BKP-4, TKP-4, and WKP-4, four button
wired keypanels.
The beltpack, via the base station, allows communications
with a digital matrix and acts as a keypanel on the system.
The base has the ability to program the frequencies of the
beltpack over-the-air. The sidetone for the base’s local head-
set and the beltpack are adjusted at the base station.
System Quick Start
The following is a list to quickly get a base station and belt-
pack operating.
1. Plug the base station into the desired Matrix port.
2. Press <MENU> as powering up the base station.
3. Set the Matrix address and options via the software
menu. Reach the parameters to set by pressing
<MENU>, then select, “System Settings”, now select
“Matrix Settings”.
4. Press <MENU> as powering-up the beltpack.
5. Press <MENU> on the beltpack until you arrive at the
encryption code screen. Press <SET> to begin editing
the 4-digit code. Set the code that you wish.
6. When finished with the encryption code, press and hold
<MENU> + <UP> for 3 seconds on the beltpack. Then
set the 4-digit base serial number on the beltpack’s dis-
play.
7. At the base station, set the 4-digit encryption code to
match the beltpack.
8. The base should now indicate, on the main status screen,
a battery voltage and signal strength indicating the base
and beltpack are communicating.
9. The beltpack should now indicate dashes on the CWW.
This indicates it is communicating with the matrix.
10. Plug a headset into the base and beltpack. Adjust the
microphone gain on both so the overmodulation light
flashes only on the loudest expected speech level.
6-1
Section
6
RKP-4B Operation