Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
40
15
16
17
17
15. Press and release the Timer button [Press and release the Timer/Info
button on the front panel twice] the volume will show on the display.
16. Press and release the Clock adjust button [Press and release the
Select button on the front panel] to adjust the volume level.
17. Press the Tuning Up or Down buttons to select the required volume
level.
18. Press the On/Off button [Standby button on front panel] again and the
radio will remain in standby mode until the alarm sounds. The alarm
symbol
will appear in the display. If the alarm has been enabled.
To enable the alarm if needed press and release the alarm button.
(see page 41)
The alarm will sound at the selected alarm time.
Note: The alarm will not sound if the alarm has not been activated
and set to the "Enabled" position. See page 41.
When the alarm is set to wake by radio your sound system will
switch on to the last used station.