Filter
Top Products
22
Using the universal remote control
Programming for use with A LASER DISC PLAYER
You may be able to program your remote to control a laserdisc
player. Use the codes shown to the right or on the sheet packed
with your remote.
Follow these steps to program your universal remote to control
your laserdisc player:
1. Turn on the laserdisc player.
2. Look up the brand and its code number(s) in the code list.
3. Press and hold the VCR2•LD button on the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR2•LD button, then press POWER to see if the laserdisc
player responds to the remote commands.
If it doesn’t, try pressing VCR2•LD, then POWER again.
6. Repeat steps 3 through 5 using the next code listed for
your brand until the laserdisc player responds to the remote
commands.
Programming the AUX button
You can program the AUX button on the remote to control another
component. The AUX button can be used to control other brands of audio
components, TVs, cable boxes, satellite receivers and VCRs.
To program the AUX button, follow these steps:
1. Turn on the component and find the brand and corresponding
code number(s) in one of the code lists in the appendices.
2. Press and hold the AUX button on the remote. Then, press the
other component button— AM/FM, TAPE, CD, DSS•CABLE, etc.
3. Release the component button, but not the AUX button.
4. Enter the three-digit code from the code list.
5. Release the AUX button, then press POWER or CHAN up (^)
or (v) to see if the component responds to the remote
commands. If it doesn’t, press AUX, then POWER again.
6. Repeat steps 3 through 6 using the next code listed for the
brand of your component until the component responds to
the remote commands.
Pioneer.................033, 037
ProScan................033, 037
RCA......................033, 037
LASERDISC
PLAYER CODES