Filter
Top Products
14
Cassette deck controls and operations
General controls
RECORD
Press to enter Record mode from the radio, CD, TV, VCR 1 or VCR2•LD, and then press PLAY to start
recording. You can only record on Deck 1.
PLAY
Press to play a tape.
NOTE: If no cassette is detected in a deck, the button will not work.
WIND
From stop mode, press to rewind the tape toward the beginning or to advance the tape
toward the end.
STOP
Press to stop current tape activity.
NOTE: This system has an Automatic Stop Feature. When the tape deck is operating in any mode
and reaches the end of the tape, it automatically shuts itself off.
PAUSE
Press to interrupt the Play or Record mode. Press PLAY to resume activity. If a deck is paused for
more than three minutes it will automatically shut itself off.
Playing Cassette Tapes
You can play cassettes from either of the two tape deck
1. Press the Tape function button to activate the cassette deck. The Tape LED will light.
2. On the cassette compartment door, press and release where it says PUSH OPEN to
open.
3. Insert a tape - exposed side down - into the compartment door and close it securely.
4. Press WIND (forward) or (reverse) to move tape to the desired starting point.
5. Press PLAY to begin playing the tape.
NOTE: Remote will only control tapes in deck 1.
PLAY / REC
TAPE
PLAY BACK
TAPE
PAUSESTOPPLAYDUBPAUSESTOPWIND
WINDPLAYRECORD HIGH SPEED DUB
PUSH OPEN
PUSH OPEN