Filter
Top Products
44
USING THE KEYPAD DIAGNOSTIC
The HTX-200 has a built-in diagnostic program that lets you con-
firm whether the keypad switches are functioning correctly. To
use this diagnostic program, follow these steps.
1. Hold down
MO
(
REV
) and turn on the transceiver.
2. Press
MO
(
REV
) again.
PrESS
dn
appears.
3. Press . If the action is correct,
PrESS
Up
appears.
4. Press . If the action is correct,
PrES
Mr
appears.
5. Press
MR (MW)
. If the action is correct,
PrESS
Sc
appears.
6. Press
SC (RPT)
. If the action is correct,
PrESS
bp
appears.
7. Press
(BEEP)
. If the action is correct,
PrESS
Lc
appears.
8. Press
LOCK (C)
. If the action is correct,
F
appears.
9. Press
FUNC
. If the action is correct,
PrES
Mo
appears.
10. Press
MO (REV)
. If this action is correct,
GOOD
appears
briefly and then the set frequency appears again.
RESETTING THE HTX-200
If the transceiver’s display locks up or the transceiver does not
work properly after you turn it on, you might need to reset it.
Caution
: This procedure clears all the information you have pro-
grammed into the transceiver. Before you reset the transceiver,
try turning it off then on again to see if it begins working properly.
To reset the transceiver, turn it off then hold down
FUNC
+
MO
and
turn it on again.
iniTial
appears to confirm the reset opera-
tion. Release
FUNC
+
MO
.
19-1102RPO.fm Page 44 Friday, June 25, 1999 11:17 AM