Filter
Top Products
27
SETTING THE REPEATER OFFSET
FREQUENCY
The HTX-200’s default repeater offset is 600 kHz, which appears
as
0.6
(MHz
)
. Follow these steps to change the offset.
Note:
This setting only affects the VFO mode. If you saved a fre-
quency offset in a memory, that setting is not affected.
1. With power off, hold down
FUNC
and turn on the HTX-200,
2. Hold down
FUNC
and repeatedly press until
rpt
and
the
current offset
appear.
0.0
appears if no offset is currently
set.
3. Repeatedly press or until the desired offset appears.
You can set an offset between 0 and 8 MHz in 100kHz
steps.
4. Press
PTT
to store the setting and exit the menu.
TURNING DUPLEX
OPERATION ON AND OFF
To turn on duplex (repeater use) operation for the VFO mode,
press
FUNC
+
SC
(
RPT
). Provided the current repeater offset val-
ue is not
0.0
, the current offset indicator (
+
above or
–
below)
appears above the displayed frequency. Press
FUNC
+
SC
(
RPT
)
again to turn it off.
19-1102RPO.fm Page 27 Friday, June 25, 1999 11:17 AM