Filter
Top Products
28
SETTING THE REPEATER OFFSET
DIRECTION
1. Set an offset frequency other than 0.0.
2. Press
FUNC
+
SC (RPT)
to see the current offset direction (
+
above or
–
below).
3. Press
FUNC
+
MO
(
REV
) to change the repeater offset direc-
tion.
Note:
To save this setting in a memory location, must be
flashing before you store the settings (see “” on Page 31 and
“Storing a Transmit/Receive Frequency” on Page 29). Otherwise,
the setting reverts to its saved value the next time you turn on the
HTX-200.
REVERSING THE TRANSMIT AND
RECEIVE FREQUENCIES
To swap the input and output frequencies, press
FUNC+PTT
. For
example, if you have set the radio to repeater operation on
146.940 with a positive offset, the radio would normally receive
on 146.94 and transmit on 146.340 MHz. After you press
FUNC
+
PTT,
the radio will receive on 146.340 and transmit on
146.940.
This feature is useful if you want to determine whether you are
close enough to another station to communicate on a simplex fre-
quency. While the other station is transmitting, reverse the fre-
quencies. If you can still hear the other station, you are hearing
their signal directly and you do not need to use the repeater.
MR
19-1102RPO.fm Page 28 Friday, June 25, 1999 11:17 AM