Filter
Top Products
Additional information
10
71
En
English Italiano Français
Nederlands
EspañolDeutsch
Considerable noise in radio
broadcasts.
• Tune in the correct frequency.
• Connect the antenna (refer to page 19).
• Route any loose cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 19).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 19).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 19).
No sound from surround or
center speakers.
• Refer to
Speaker setting
on page 46 to check the speaker settings.
•
VSX-D714/D814 only –
Refer to
Manually calibrating your listening
area (MCACC)
on page 52 to check the speaker levels.
• Connect the speakers properly (refer to page 20).
No sound from surround
back speakers
(VSX-D714/
D814 only)
.
• Refer to
Surround back speaker setting
on page 46 to check the
surround back speaker settings.
• Refer to
Manually calibrating your listening area (MCACC)
on
page 52 to check the speaker levels.
• Refer to
Using the Surround Back Channel (SB CH)
on page 39 to
make sure the
SB CH MODE
and the sound mode are set for
surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• Switch the
Subwoofer setting
on page 47 to
YES
or
PLUS
.
• Switch the
LFE attenuator setting
on page 47 to
0 dB
or
10 dB
.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SELECT
to
AUTO
,
DIGITAL
or
ANALOG
according to the type of connections made. (refer to page 38).
• Set the digital input settings correctly (refer to page 50).
• Make digital connections (refer to page 15) and set the
SIGNAL
SELECT
to
DIGITAL
(refer to page 38).
• Refer to the instruction manual supplied with the DVD player.
Problem
Remedy
VSX_514-814.fm 71 ページ ２００４年３月２日 火曜日 午後８時３５分