Filter
Top Products
5 minute guide
02
11
En
English Italiano Français
Nederlands
EspañolDeutsch
• If you select subwoofer (
SB SW
) in the
Surround back speaker setting
on page 46 you can
hook up a subwoofer instead of speakers to the surround back speaker terminals. Connect
the wires just as above (and as shown below), connecting the positive wire to the right
channel (
+
) terminal, and the negative wire to the left channel (
–
) terminal.
4 Plug in the receiver and switch it on, followed by your DVD player, your subwoofer
and the TV.
Make sure you’ve set the video input on your TV to this receiver. Check the manual that came
with the TV if you don’t know how to do this.
Also make sure that
DVD/LD
is showing in the receiver’s display, indicating that the DVD input
is selected. If it isn’t, press
DVD
on the remote control to set the receiver to the DVD input.
5 Press QUICK SETUP on the front panel to specify your speaker setup, room size and
listening position.
Use the
MULTI JOG
dial to select and
ENTER
to confirm your selection. See
Using the Quick
Setup
on page 12 if you’re unsure about the settings.
6 Play a DVD, and adjust the volume to your liking.
There are several other sound options you can select. See
Listening to your system
on page 36
for more on this. See also
Choosing your receiver setup
on page 44 for more setup options.
• Depending on your DVD player or source discs, you may only get digital 2 channel stereo
and analog sound. In this case, the listening mode must be set to
STANDARD
(it should
already be set—see
Listening in surround sound
on page 36 if you need to do this) if you
want multichannel surround sound.
RL
SURROUND BACK
Surround back
speaker (or
subwoofer)
VSX-D814
VSX_514-814.fm 11 ページ ２００４年３月２日 火曜日 午後８時３５分