Filter
Top Products
Setting up the receiver
06
53
En
English Italiano Français
Nederlands
EspañolDeutsch
5 Use
and
to adjust the delay for
each channel in turn, pressing ENTER to go
to the next channel when you’re done.
Listen to the reference channel and use it to
measure the target channel. Stand facing the
two speakers with your arms outstretched
pointing at each speaker. Try to make the two
tones sound as if they are arriving simulta-
neously at a position slightly in front of you
and between your arm span.
The test tone for channel delay is output in the
same order as step 5:
After you have completed all the channels in
your speaker setup, the volume level returns
to normal and
COMPLETE
, then
RESUME
shows in the display.
The MCACC indicator then lights to show that
MCACC setup is complete.
• Using the MCACC system to set up your
speaker system will overwrite any
previous settings you had for the
STANDARD
or
ADVANCED SURROUND
modes.
Setting separate channel
levels for listening modes
• Default setting:
0 dB
You can set relative channel levels from the
listening position using the method below
(this is similar to the VSX-D714/D814 MCACC
setup). Using
CH SELECT
(see tip below), it is
also possible to set separate channel levels
for each of the listening modes.
1 Press STANDARD or ADVANCED
SURROUND.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
• If you don’t hear a test tone from one of
your speakers, please refer to
Speaker
setting
on page 46 and
(VSX-D714/D814
only)
Surround back speaker setting
on
page 46 to make sure you have correctly
specified your speaker setup.
RC
RS
LS
SW SB
STANDARD
SURROUND
ADVANCED
LEVEL
TEST
TONE
MASTER
V OLUME
CH
SELECT
LC
RS
R
LS
SW SB
VSX_514-814.fm 53 ページ ２００４年３月２日 火曜日 午後８時３５分