Filter
Top Products
5 minute guide
02
12
En
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to
Choosing your receiver setup
on
page 44.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
VSX-D714/D814 only –
SW DET
flashes in the
display while the receiver checks your setup
for a subwoofer.
SW YES
or
SW NO
confirms
the subwoofer check, then the display
prompts you to select your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
VSX-D714/D814 –
When a subwoofer was
detected in step 2, you can cycle between the
following choices:
*
VSX-D814 only
If a subwoofer wasn’t detected in step 2, you
can cycle between the following choices:
*
VSX-D814 only
VSX-D514 –
Cycle between the following
choices:
• Check the table below to find the speaker
setup that corresponds with your system.
*
VSX-D714/D814 only
**
VSX-D814 only
UPDOWN
MULTI JOG
MASTER VOLUME
ENTER
SPEAKERS
S-VIDEODIGITAL IN VIDEO
L AUDIO R
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
SB CH
MODE
T
ENING MODE
TONE
QUICK SETUP
MMER
VIDEO INPUT
MULTI JOG
7.1ch*
4.1ch
6.1ch
5.1ch
2.1ch 3.1ch
7.0ch*
4.0ch
6.0ch 5.0ch
2.0ch 3.0ch
5.1ch
2.0ch 4.0ch
5.0ch 4.1ch
2.1ch 3.0ch
3.1ch
VSX_514-814.fm 12 ページ ２００４年３月２日 火曜日 午後８時３５分