Filter
Top Products
23
Set up
1
Press SETUP and hold for three seconds to
select the preset mode.
The LED will blink twice.
To cancel the preset mode
Press SETUP.
2
Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the following components
DVD
: DVD/LD player or DVD Recorder
TV
: TV , Satellite tuner or Cable TV tuner
CD
: CD player, CD-R, Tape deck or MD recorder
CD-R
: CD player, CD-R, Tape deck or MD recorder
VCR
: VCR or Digital Video Recorder
TVC
: TV , Satellite tuner or Cable TV tuner
TUN
: FM/ AM tuner
3
Use the number buttons to enter the 4 digit
setup code.
The LED will blink after each digit is input and will blink twice to
confirm a valid code has been input.
If the LED shows one long blink it means an invalid code has been
input. Check the preset code list and try again. If you are not able
to input a preset code you can refer to page 26 to teach the remote
control individual commands.
Repeat steps 1 through 3 to assign preset codes for as many
components as necessary.
4
Press SETUP to exit the preset mode.
The remote control returns to the previous operation mode.
It will also return to the previous mode after ten seconds of
inactivify.
• The RCV (Receiver) button cannot be preset.
• You can only input a code for the component type written
on each MULTI CONTROL button. See page 29 for
information on how to program a different type of
component than specified on the button.
• If you recall a preset code for the tuner (TUN MULTI
COTROL), you will not be able to control the built-in tuner
of this receiver using the remote. To reset the remote to
the built-in tuner, input the preset code 0080.
Setting Up the Remote Control
In addition to controlling the receiver, the supplied remote control can operate your other components (DVD,
MD, VCR, TV, LD, CD, etc.). If your component(s) are listed in the “Preset Code List”, simply recall the
corresponding preset code.
Recalling preset codes (VSX-D509S)
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset
code is assigned, pressing the button will automatically set the remote to operate the respective component.
• Refer to “Preset Code List” on pages 53 to 56 for the components and manufacturers
available.
• Refer to “Controlling the Rest of Your System” on pages 46 to 50 for detailed explanations
on how to operate your other components.
3
memo
2
1,4
Preparations
Î
SOURCE
ENTER
TV CONTROL
TV VOL
TVFUNC
TV
MENU
ENTER
D.ACCESS BAND CLASS
CH SELECT CH LEVEL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
DSP TEST TONE
FL DIMMER
LOUDNESSFUNCTION SETUPMUTING
MPX DTV ON / OFF DTV MENU
FQ
FQ
ST ST
CHANNEL
MASTER VOLUME
DISC
MULTI CONTROL
DVD TV VCR CD-R
RCV CD TUN TVC
RECEIVER
7
4
¢
3
1
¡
8
2
MIDNIGHT
SIGNAL SELECT EFFECT
+10
5.1CH ATT
123
456
789
0
LED
()
memo