Filter
Top Products
09
48
En
Controlling the rest of your system
Setting Up Using Full Library
Search
An alternative method of setting up the remote
with preset codes is to use the Library Search
feature. The remote transmits batches of 10
codes; when you see the component you want
to control respond (by turning on or off) you
just scan through those last 10 codes until you
find the correct one.
LEARN ERASE SEARCH BY BRAND
RECEIVER
SOURCE
TV
TV INPUT
MENU
TV VOL
MASTER VOLUME
TV CONTROL
CHANNEL
ENTER
ENTER
MPX/RETURNDTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T
P
S
E
U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO
SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR.
STEREO
ANGLE
1¡
4
¢
7
8
3
¶
LEVEL
DVD VCR C D-RTV
RCV
TUN
TVC
CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL.
MUTE
MIDNIGHT/
LOUDNESS
SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY
DISC
+10
1
2
3
4
5
6
7
8
9
0
1 Switch on the component you want to
control.
If the component is some kind of player (CD
player, VCR, etc.), then start it playing.
2 Press and hold REMOTE SETUP for
three seconds.
The LCD display shows SETUP.
3 Press the MULTI CONTROL button for
the component you want to control.
4 Use the } and ] buttons to select the
SEARCH.
The LCD display shows SEARCH.
5 Press and hold REMOTE SETUP for
three seconds.
A batch of 10 codes is transmitted and the
transmit icon blinks during transmission.
If you see the component respond, by
stopping (for playback components only) or
switching off, go on to the step 6, otherwise
press and hold the REMOTE SETUP button
for three seconds.
Cancelling this step can only be done after
the 10 codes are transmitted.
6 Switch the component back on or
restart playback.
7 Use ’ and ‘ buttons to scan step-by-
step through the last 10 codes
transmitted to identify the correct code.
Stop when you see the component stop or
switch off. The LCD display shows the I.D.
You can also verify you have the correct
code by pressing PLAY, STOP., VOL +/–, etc.
8 Press and hold ENTER for three
seconds to save the preset code.
The LCD display shows OK.
The remote control automatically returns to
normal usage.
• Unless otherwise stated, you can cancel or
exit any of the steps by pressing and holding
MUTE for three seconds.
• The remote control will return to its previous
mode after 30 seconds of inactivity.