Filter
Top Products
Setting up the receiver
06
37
En
Component video input setting (page
40)
Specify the components to be assigned
to the component video inputs (below).
• Component video 1 input setting
• Component video 2 input setting
Surround back channel input setting
(page 40)
Specify the number of surround back
inputs you have connected.
Digital input settings (page 41)
Specify the components to be assigned
to the video and digital inputs (below).
• Coaxial digital input 1 setting
• Coaxial digital input 2 setting
• Optical digital input 1 setting
• Optical digital input 2 setting
4 Use ’ or ‘ to adjust the setting.
The setting is entered automatically.
5 Repeat steps 3 and 4 to set other
surround modes.
6 When you’re done, press ENTER to exit.
The setting display is automatically exited
after 20 seconds of inactivity.
Speaker setting
• Default setting: S (all speakers)
You must let the receiver know how many
speakers you have, and how big they are. The
size you choose (large or small) determines
how much bass is sent from the receiver to the
speakers.
In the display, F, C, and S refer to front, center,
and surround speakers respectively. Speaker
size is denoted as L for large speakers, S for
small speakers, and (asterisk) if no speaker is
connected.
• If the cone size (diameter) of the
speaker is larger than 5 inches, set the
speaker size to L.
• If you’re not using a subwoofer, we
recommend setting the front speakers to L.
• Cycle through the available choices
using ’ or ‘ and choose a configuration
that matches your speaker setup.
One of the following configurations should
match your setup:
FL-CL-SL
FL-CL-SS
FL-CL-S
FL-CS-SL
FL-CS-SS
FS-C -SS
FS-CS-S
FS-CS-SS
FL-C -SS
FL-C -SL
FL-CS-S
Surround back speaker setting
• Default setting: S
You must let the receiver know if surround back
speaker(s) have been connected, and how big
they are. The size you choose (large or small)
determines how much bass is sent from the
receiver to the speakers. If you have connected
a surround back subwoofer, you should select
the surround back subwoofer setting (SB
SUBWF) from the options. Choose (asterisk) if
no speaker is connected.
• Use ’ or ‘ to select SB L, SB S, SB or
SB SUBWF.