Filter
Top Products
Setting up the receiver06
42
En
Setting the relative volume level
of each channel
• Default setting: 0db
For best surround sound playback, you should
set the relative channel levels from the main
listening position. You can set separate levels
for each surround mode.
1 Press RCV.
2 Press STANDARD.
3 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
FL C
SR
FR
SLSW
SB
If you don’t hear a test tone from one of
your speakers, please refer to Speaker
setting on page 37 to make sure you have
correctly specified your speaker setup.
4 Press MASTER VOLUME +/– to adjust
the volume to an appropriate level.
5 Use LEVEL +/- to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level range
is ± 10 dB.
6 When you’re done, press TEST TONE to
turn off the test tone.
The speaker volume can be adjusted
without outputting the test tone by
pressing CH SELECT and then using
LEVEL +/–.
LEARN ERASE SEARCH BY BRAND
RECEIVER
SOURCE
TV
TV INPUT
MENU
TV VOL
MASTER VOLUME
TV CONTROL
CHANNEL
ENTER
ENTER
MPX/RETURNDTV INFO
DTV ON/OFF DTV MENU
D.ACCESS T.EDIT/GUIDE
ST
TUNE
T
P
S
E
U
TUNE
ST
CLASS
FL DIMMER
BAND
TOP MENU AUDIO
SUB TITLE
REMOTE SETUP
RECEIVER CONTROL
STANDARD ADV.SURR.
STEREO
ANGLE
1¡
4
¢
7
8
3
¶
LEVEL
DVD VCR C D-RTV
RCV
TUN
TVC
CD
TEST TONE
CH SELECT
INPUT ATT
INPUT SEL.
MUTE
MIDNIGHT/
LOUDNESS
SIGNAL SEL
MULTI CONTROL
EFFECT DISPLAY
DISC
+10
1
2
3
4
5
6
7
8
9
0
• Test tone is only output in Standard
modes.
• Since the subwoofer transmits an ultra-
low frequency its sound may seem quieter
than it actually is.