Filter
Top Products
Setting up the receiver06
40
En
Dynamic range control setting
• Default setting: OFF
Dynamic range is the difference between the
loudest and softest sounds in any given signal.
With this setting, you can compress the
dynamic range, so that low level sounds can be
heard more easily (sounding relatively louder)
yet louder sounds won’t be too overbearing.
• Press ’ or ‘ to set the dynamic range
control (OFF, MAX, or MID).
• When the volume level is increased, set
to OFF.
• When listening at low volumes, set to
MAX for maximum dynamic range
compression.
• Dynamic range control is effective only
when a Dolby Digital signal is being played
back.
Dual mono setting
• Default setting: ch1
The dual mono setting can only be used when
listening to Dolby Digital discs with dual mono
encoding. These discs are not widely used, but
are sometimes used when it is necessary to
have one language on one channel and a
different language on the other. With this
setting you can choose which channel in the
dual mono setting you want to listen to.
You will hear the channel you have selected
(either ch1 or ch2) through your center speaker.
If you don’t have a center speaker, you will hear
the channel you have selected through both
front speakers. In the L ch 1. R ch 2 setting, the
left front speaker will play channel 1 and the
right front speaker will play channel 2.
• Use ’ or ‘ to cycle through the
possible dual mono settings.
ch2
L ch 1.R ch 2
ch1
Component video input settings
Here you tell the receiver what components you
have hooked up to the component video jacks
on the back of the receiver.
Component video 1:
• Default settings: DVD
1 Use ’ or ‘ to assign the component
video 1 input (DVD, TV, VCR or OFF).
Component video 2:
• Default setting: TV
2 Use ’ or ‘ to assign the component
video 2 input (DVD, TV, VCR or OFF).
Surround back channel input
setting
• Default setting: SB 2ch IN
You only have to make this setting if you are
using a separate component for decoding
DVDs, and the component has only one
surround back channel output. If this is the
case, select SB 1ch IN, otherwise leave it set to
SB 2ch IN.
• Use ’ or ‘ to select SB 2ch IN or
SB 1ch IN.