Filter
Top Products
Listening to your system
05
22
En
Listening with Acoustic Calibration EQ
You can listen to sources using the Acoustic Calibration
EQ set in
Using the Auto MCACC setup for optimal
surround sound
on page 18.
1 Press
SOUND
.
2 Use the
/
(cursor left/right) buttons to select
MCACC EQ then press
ENTER
.
3 Use the
/
(cursor up/down) buttons to switch
EQ ON or EQ OFF then press
ENTER
to confirm.
• On the
EQ OFF
setting, equalization is set to off and
speaker settings (channel delay and channel level)
remains as it is set.
• Acoustic Calibration EQ is set to on automatically
after Auto MCACC setup is used.
Enhancing dialogue
The Dialogue Enhancement feature is designed to make
the dialogue stand out from other background sounds in
a TV or movie sound track.
1 Press SOUND.
2 Use the
/
(cursor left/right) buttons to select
DIALOGUE then press ENTER.
3 Use the
/
(cursor up/down) buttons to select
the amount dialogue enhancement then press
ENTER to confirm.
Select between
OFF
,
MID
or
MAX
.
Using Quiet and Midnight listening
modes
The Quiet listening feature reduces excessive bass or
treble in a sound source.
The Midnight listening feature allows you to hear
effective surround sound of movies at low volume levels.
1 Press SOUND.
2 Use the
/
(cursor left/right) buttons to select
TONE then press ENTER.
3 Use the
/
(cursor up/down) buttons to select
QUIET or MIDNIGHT then press ENTER to confirm.
• To cancel the Quiet or Midnight listening modes,
select
BASS/TRE
.
Adjusting the bass and treble
Use the bass and treble controls to adjust the overall
tone.
1 Press SOUND.
2 Use the
/
(cursor left/right) buttons to select
TONE then press ENTER.
3 Use the
/
(cursor up/down) buttons to select
BASS/TRE then press ENTER.
• Selecting
BASS/TRE
cancels the Quiet and Midnight
listening modes. These modes cannot be used at the
same time.
4 Use the
/
(cursor left/right) buttons to select
BASS or TREBLE; use the
/
(cursor up/down)
buttons to adjust the sound then press ENTER to
confirm.
Boosting the bass level
There are two bass modes you can use to enhance the
bass in a source.
1 Press
SOUND
.
2 Use the
/
(cursor left/right) buttons to select
BASSMODE then press
ENTER
.
3 Use the
/
(cursor up/down) buttons to select the
sound then press
ENTER
to confirm.
Select between
OFF
,
MUSIC
or
CINEMA
.
ST
TUNE
TUNE
ST
ENTER
ENTER
CLEAR
SOUND
SETUP
TEST
TONE
SOUND
RETRIEVER
MCACCADVANCED F.S.SURRSURROUND
SLEEP
SR
ST
TUNE
TUNE
ST
ENTER
SOUND
HTS-570.book 22 ページ ２００７年１月２９日 月曜日 午後９時７分