Filter
Top Products
Connecting up
02
11
En
English
Chapter 2
Connecting up
Basic connections
Important
• When connecting this system or changing connections, be sure to switch power off and disconnect the power
cord from the wall socket.
After completing all connections, connect the power cord to the wall socket.
1 Fasten the spacers to the display unit and connect.
If the display unit is difficult to view, the spacers can be
attached to allow changing of the viewing angle. Peel off
the protective paper from the spacers and press the
spacers onto the depressions on the bottom of the display
unit.
Plug the L-shaped end of the display cable into the
connector on the rear of the display unit, then plug the
other end of the display cable into
SYSTEM CONNECTOR
jack on the receiver subwoofer.
MCACC
SETUP MIC
SYSTEM CONNECTOR
AC IN
CONTROL IN
CONTROL
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
OUT
SUBWOOFER
CENTER FRONT
SURROUND
DVD
(COAXIAL)
DTV
(OPTICAL)
PC/GAME
(OPTICAL)
SPEAKERS
DIGITAL
AUDIO INPUT
ANALOG
AUX
AM LOOP ANTENNA
FM UNBAL 75
RL
RL
R
L
AM loop antenna
Display unit
Receiver subwoofer
2
Display cable
FM antenna
1
3
HTS-570.book 11 ページ ２００７年１月２９日 月曜日 午後９時７分