Filter
Top Products
Additional information15
54
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem
Remedy
The power does not turn on. • Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure the power source is the right voltage for the AC inlet.
The power suddenly switches off
automatically and won’t switch
back on for a minute or so. Also,
the timer indicator is blinking.
• If the speaker cables aren’t connected properly, the system has a
safety feature that shuts the power off automatically. Check the
speaker wires to make sure they’re connected properly. If there
appears to be nothing wrong, try switching the power back on after
the timer indicator has been blinking for a minute or so.
• If you can’t seem to switch the power back on after the timer
indicator has been blinking for over a minute, the unit may be
malfunctioning. Take it to your nearest Pioneer authorized service
center or your dealer to carry out repair work.
No sound is output when a
function is selected.
• If you’re using the
LINE
input, make sure the component is
connected correctly (see
Connecting auxiliary components
on
page 12).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the volume.
No image is output when
watching discs.
• Make sure the TV is connected correctly (see
Connecting to your
TV
on page 11).
System does not output digital
audio at 96kHz.
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if 96 kHz is selected, the player
automatically outputs the audio at 48 kHz. This is not a
malfunction.
Can’t operate the remote control. • Replace the batteries (see
Loading the batteries
on page 6).
• Operate within 23 feet (7 m), 30° of the remote sensor on the front
panel (see
Range of the remote control unit
on page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
EV-500-1000.book 54 ページ ２００５年４月５日 火曜日 午後１２時３１分