Filter
Top Products
15
4 Getting Started
English
En
Setting the clock
This system has a built in clock, which needs to be set to be able to use the timer features.
Note: If there is a power failure or the system is unplugged from the wall outlet, the
display shows AM 12:00 once power is restored until you set the clock again.
1 Switch on.
You can use the STANDBY/ON button on the top panel, or the POWER button on
the remote control.
2 Press and hold the DISPLAY/CLOCK button until the display
shows TIME?.
3 Press ENTER.
The display shows AM 12:00, with the hour blinking.
4 Use the 4 and ¢ buttons to set the hour, then press ENTER.
5 Use the 4 and ¢ buttons to set the minute, then press ENTER.
DISPLAY
/CLOCK
ENTER
POWER
4¢
REMOTE CONTROL UNIT
FUNCTION
VOLUME
DISPLAY/
CLOCK
TIMER
ENTER (DEMO)
DISPLAY/
CLOCK
ENTER
STANDBY
STANDBY/ON
BASS/TREBLE
CD SELECT
OPEN/CLOSE
TUNING
!⁄
›
$
)
)
)
&
#*
1
2
3
Switching on the clock in standby
If you want to display the time when the system is in standby, the clock can be set to
appear in your display. However, to consume less power, you can leave the clock off (this is
the default setting).
1 Switch on.
You can use the STANDBY/ON button on the top panel, or the POWER button on
the remote control.
2 Press and hold DISPLAY/CLOCK until the display shows TIME?.
3 Use the 4 or ¢ button to select TIME ON or TIME OFF.
Set to TIME ON if you want to be able to display the time when the system is in standby.
This may be convenient, but the standby power consumption is higher.
Set to TIME OFF if you don't need the clock display in standby. Standby power
consumption is lower on this setting.
4 Press ENTER.
Tip
If you have chosen the TIME OFF setting, you can still display the clock for 4 seconds in
standby by press DISPLAY/CLOCK.
When set to TIME ON, the clock is displayed after switching the system into standby. If
you press STANDBY/ON (top panel) / POWER (remote) again within 2 seconds
of the clock being displayed, the system remains in standby, but the clock display
disappears.