Filter
Top Products
29
Operation
Playing Sources with Dolby Digital or DTS Sound
Sound Modes
1
Follow steps 1 to 3 of the playback
procedure. (Refer to “Playing a source” on
the previous page.)
1 Turn on the power of the playback component.
2 Turn on the power of the receiver.
3 Press FUNCTION to select the source component you want to
play.
2
Press SIGNAL SELECT to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input” on the
previous page.)
3
Press 2 to switch the Dolby/DTS mode on.
4
Start playback of the component you
selected in step 1.
5
Press MASTER VOLUME (+/–) to adjust the
volume level.
• When an LD or CD player compatible with DTS is
played back with SIGNAL SELECT set in “ANALOG”,
digital noise is output caused by playing back the DTS
directly (no decoding). To prevent noise, you need to
make digital connections (refer to pages 11) and set
SIGNAL SELECT to “DIGITAL”.
2
35
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the 2 RF (AC-3) output, a commercially available
RF demodulator (RFD-1) is required. The RF demodulator changes the RF signal to a digital signal
which is then processed by the receiver at the digital input jacks. For more details, refer to the instruction
manual supplied with the RFD-1.
memo
2
1
3
5
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
Î
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
memo
1
2