Filter
Top Products
28
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
Î
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
Switching ANALOG/DIGITAL Signal Input
Set this switch to tell the receiver whether you’re using a component that is hooked up digitally or in an analog
manner. If you have no components connected digitally the switch wonb’t allow you to select digital.
1
Press SIGNAL SELECT to select the input
signal corresponding to the source
component.
Each press switches between ANALOG and DIGITAL signal
selection.
2
While SIGNAL SELECT is set to DIGITAL,
DIGITAL lights when a Dolby Digital signal is
input, DTS lights when a DTS signal is input.
SIGNAL
SELECT
• SIGNAL SELECT is fixed in the “ANALOG” position for components
not assigned to one of the two digital input jacks.
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), DTS, digital signal formats. With digital signal formats other
than these, set SIGNAL SELECT to “ANALOG”.
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in “ANALOG”, digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you
need to make digital connections (Refer to page 11) and set SIGNAL
SELECT to “DIGITAL”.
• Some DVD players don’t output DTS signals. For more details, refer to
the instruction manual supplied with your DVD player.
• Audio from a karaoke microphone and some LDs are analog so set the
SIGNAL SELECT to “ANALOG” in these cases.
• For analog LDs and karaoke microphones, set the switch to
“ANALOG.”
Sound Modes
memo
AT T
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
1234
5678
90
‡
SIGNAL SELECT
1
Turn on the power of the playback
component.
2
Turn on the power of the receiver.
Be sure that the standby indicator turns off on
the front panel.
3
Press MULTI CONTROL buttons or the
FUNCTION button to select the source you
want to playback.
If the DIRECT FUNCTION is OFF you have to use the FUNCTION
button to select the source (see p.22).
4
If necessary, press SIGNAL SELECT to select the
input signal corresponding to the source
component (as above).
5
Start playback of the component you selected
in step 1.
Playing a Source
3
2
3
4
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
DIGITAL
SIGNAL
SELECT
ANALOG
DIGITAL
2DIGITAL
SIGNAL
SELECT
ANALOG
DIGITAL
DTS
Each press switches between ANALOG
and DIGITAL signal selection.
When a Dolby Digital
signal is input.
When a DTS
signal is input.