Filter
Top Products
Additional information10
50
En
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 18).
No sound from surround or
center speakers.
• Connect the speakers properly. Refer to page 19 (VSX-415) or
page 20 (VSX-515).
• Refer to
Speaker setting
on page 38 (VSX-415) or page 42 (VSX-515)
to check the speaker settings.
•
VSX-415 only –
Refer to
Setting separate channel levels for listening
modes
on page 40 to check the speaker levels.
•
VSX-515 only –
Refer to
Channel level
on page 43 to check the
speaker levels.
No sound from surround
back speakers
(VSX-515 model
only)
.
• Refer to
Speaker setting
on page 42 to check the surround back
speaker settings.
• Refer to
Channel level
on page 43 to check the speaker levels.
• Refer to
Using the surround back channel (Extended mode)
on
page 33 to make sure the Extended mode and the sound mode are
set for surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
VSX-415 model only:
• Switch the
Subwoofer setting
on page 38 to
YES
or
PLUS
.
• Switch the
LFE attenuator setting
on page 38 to
0 dB
or
10 dB
.
VSX-515 model only:
• Switch the subwoofer setting in
Speaker setting
on page 42 to
YES
or
PLUS
.
• Switch the
LFE Attenuator Setup
on page 45 to
LFEAT 0
or
LFEAT
10
.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SELECT
to
AUTO
,
DIGITAL
or
ANALOG
according to the type of connections made. (refer to page 32).
• Set the digital input settings correctly. Refer to page 40 (VSX-415)
or page 44 (VSX-515).
• Make digital connections (refer to page 13) and set the
SIGNAL
SELECT
to
DIGITAL
(refer to page 32).
• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
Problem
Remedy
VSX_415-515.fm 50 ページ ２００４年１２月８日 水曜日 午後３時１２分