Making recordings09
48
En
Chapter 9:
Making recordings
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV).
1
Keep in mind you can’t make a digital
recording from an analog source or vice-versa,
so make sure the components you are
recording to/from are hooked up in the same
way (see
Connecting up
on page 12 for more on
connections).
* Illustration shows the VSX-515 model
1 Select the source you want to record.
Use the input select buttons (
INPUT
SELECTOR
).
2 Select the input signal (if necessary).
Press
SIGNAL SELECT
to select the input
signal corresponding to the source component
(see page 32 for more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
2
Refer to the instructions that came with the
recorder if you are unsure how to do this. Most
video recorders set the audio recording level
automatically—check the component’s
instruction manual if you’re unsure.
5 Start recording, then start playback of the
source component.
Note
1
VSX-515 only
– If you are recording a video source, you need use the same type of connection for the source as for the recorder.
For example, you can’t record a component hooked up to composite video jacks with a recorder hooked up to the component
video outputs (see
Connecting other video components
on page 16 for more on video connections).
INPUT SELECTOR
RECEIVER
CD-R/
TAPE/MD
MIDNIGHT/ADVANCED
SLEEP
DVD/LD
CD FM AM
TV/SAT DVR/VCR
DVD 5.1CH
FL DIMMER
INPUT ATT
EFFECT/CH SEL
DIALOG E
LEVEL
SIGNAL
SELECT
TUNER
EDIT
TUNER
CLASS
MPX
DVD
AUDIO
DISPLAY
TUNING STATION
MUTE
VOLUME
RECEIVER CONTROL
2 The receiver's volume, balance, tone (bass, treble, loudness), and surround effects have no effect on the recorded signal.
VSX_415-515.fm 48 ページ 2004年12月8日 水曜日 午後3時12分