Filter
Top Products
Expert System Settings
92
5Use the buttons to adjust the
frequency. When you have it at the
level you want press ENTER.
Set the frequencies within the –6 dB to +6 dB range in
steps of 0.5 dB. If OVER appears in the display you have
set the levels too high. Reduce them until OVER
disappears.
6 The cursor automatically goes to the
next frequency. Press ENTER and
repeat steps 4 and 5 to adjust all the
frequencies.
7 TRIM should be selected (if it isn’t use
the buttons to select it) and press
ENTER.
8Use the buttons to adjust the
TRIM and press ENTER.
TRIM will balance the volume level of each frequency in
the overall volume of that speaker.
9 EXIT should be selected (if it isn’t use
the buttons to select it) and press
ENTER.
10The cursor automatically goes to the
next channel. Press ENTER and repeat
steps 3 – 8 to adjust all the channels.
11EXIT should be selected (if it isn’t use
the buttons to select it) and press
ENTER.
Leave the setup by using the buttons to select EXIT
and pressing ENTER. You can now go to DATA CHECK or
leave the ACOUSTIC CAL EQ setting by using the
buttons to select EXIT and pressing ENTER.
5
7
9
00_VSX-53TX.book Page 92 Monday, April 7, 2003 11:07 PM