Filter
Top Products
Basic Operation
56
Video Select
This function allows you to listen to one sound source while you watch a different video source on your TV. The
sound source is set in the normal fashion as explained on page 43. You then change the video input with the VIDEO
SEL button.
1 Press RECEIVER.
2 Press the VIDEO SEL button on the
remote control to cycle through the
different possible video inputs.
The first press shows the video input you are currently
using. After that pressing VIDEO SELECT cycles though
the possibilities in the following order:
The OFF setting means you are listening without a video
signal. (Also, when you select CD, CD-R/TAPE1, MD/
TAPE2, TUNER or LINE the VIDEO SELECT will be set to
off.)
Memo:
• The VIDEO SELECT remains set to the input you chose
until you change the audio input.
• If you change audio functions the receiver will reset
itself to make the video and audio inputs correspond.
Also, if you switch the power of the receiver off when
you turn it back on the video and audio inputs will reset
so that they correspond.
Adjusting the Brightness of the Display (DIMMER)
Use the display DIMMER button to adjust the brightness of the fluorescent display.
1 Press RECEIVER.
2 Use the display DIMMER button on
the remote control to alternate
between the different levels of
brightness for the display.
Four levels of brightness ranging from very dim to very
bright can be selected. Also, when set to very dim, the
MCACC indicator will turn off.
Memo:
It is a feature of this unit that the fluorescent display will
be brighter for a few seconds after you choose a function
(like DVD/LD, CD, etc.) and then get softer. This will still
happen when you adjust the brightness but the new
setting will be the one the display softens to.
00_VSX-53TX.book Page 56 Monday, April 7, 2003 11:07 PM