Filter
Top Products
Fine Tuning Your System
84
12V TRIGGER function
This feature allows you to hook up equipment (for example, a relay device) to this receiver that will send a power
signal automatically when you select the function turned on here (for example, DVD/LD). To use this feature follow
the steps below.
Connect the equipment you want to use with this fea-
ture to the 12V TRIGGER terminal on the back panel.
1 Turn on the receiver and your TV,
press RECEIVER on the remote con-
trol.
2 Press the SYSTEM SETUP button.
3 Looking at the on-screen display on
your TV, use the buttons to select
12V TRIGGER. Press the ENTER
button.
4Use the buttons to select the
component you want to use the 12V
trigger with (for example, DVD/LD).
Press ENTER.
5Use the buttons to select the ON
or OFF. Press ENTER.
ON: 12V TRIGGER function is activated.
OFF: 12V TRIGGER function is not activated.
6 Repeat steps 4 and 5 to set 12V
TRIGGER for as many terminals as you
want.
7Use the buttons to select EXIT
and press ENTER. EXIT should be
selected (if not, use the buttons
to select it). Press ENTER.
This exits the SYSTEM SETUP mode and returns to
normal operation.
Memo:
• Use a mono mini cord to hook up the 12V TRIGGER
equipment.
• DC OUT12V/100mA is the maximum power.
3
4
3-7
2
00_VSX-53TX.book Page 84 Monday, April 7, 2003 11:07 PM