Filter
Top Products
Using the Tuner
58
Direct Access Tuning
The following steps show you how to tune directly to a specific frequency using the remote control.
1 Press the TUNER button.
This selects the tuner function on the receiver and sets
the remote to the tuner operation mode.
2 Press the BAND button to select the
band (FM or AM).
Each press switches the band: FM AM
3 Press the D.ACCESS button to
activate the direct access tuning
mode.
The cursor blinks in the display on the front panel.
4 Use the number buttons to enter the
frequency of the station you want.
Example:
To tune station 106.00 (FM), press: 1 0 6 0 0
To cancel before inputting the frequency
Press D.ACCESS, and enter the frequency again.
09.Using_the_Tuner.fm Page 58 Thursday, April 10, 2003 5:55 PM