Filter
Top Products
Connecting Your Equipment
20
Connecting Analog Audio Components
Before making or changing the connections, switch off the power and disconnect the power cord from the AC
outlet.
Connect your audio components to the jacks as shown below. These are all analog connections and your
analog audio components (turntable, cassette deck) use these jacks. Remember that for components you
want to record with you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for
components that only play (like a turntable) you only need to hook up one set of stereo plugs (two plugs). If
you want to record to/from digital components (like a CD-R) to/from analog components you must hook up
your digital equipment with these analog connections.
*The arrows indicate the direction of the audio signal.
Memo:
Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck
which is caused by leakage flux from the transformer in the receiver. If you experience noise, move the
cassette deck farther away from the receiver.
ANALOG
Audio cords
Use (RCA) audio cords (not supplied) to
connect the audio components.
Connect red plugs to R
(right) and white plugs
to L (left).
Be sure to insert
completely.
CD player
Cassette deck
CD recorder
Turntable (etc)
If you use a turntable with this
LINE IN jack only connect one
with a built-in phono equalizer.
00_VSX-53TX.book Page 20 Monday, April 7, 2003 11:07 PM