Pioneer M-NS1 Stereo Amplifier User Manual


 
16
4 Getting Started
6 To skip back or forward to another track,
press (but don't hold) 4 or ¢ .
Pressing ¢ once skips to the start of the next track on the
disc. Further presses take you to subsequent tracks.
Pressing 4 once takes you to the beginning of the current
track. Further presses skip to the start of previous tracks.
You can use the track skip buttons while the disc is paused,
too. The track number changes while the disc remains
paused.
7 To stop playback, press 7.
If the disc was paused, then pause is canceled. The display
shows the number of tracks on the disc and the total playing
time when the disc is stopped.
Tip
In step 2 above, pressing the CD button closed the disc
compartment and set the disc playing. In fact, pressing this
button is always the quickest way to play a disc. If there's
already a disc in the player, then pressing the CD button—
even when the system is in standby mode—will switch the
system on and start the disc playing.
Caution!
Be careful not to trap your fingers in the disc compartment as
it closes automatically.
About the automatic door open
sensor
The automatic opening of the disc compartment works using
an infrared sensor. It may not work reliably if:
the sensor is exposed to direct sunlight
the room is lit using fluorescent lights
the unit is on a dark-colored surface
the unit is placed adjacent to a wall or other surface
40
15cm
20
On its default setting, the door open sensor may open the disc
compartment even if a CD is playing. You can change this so
that it will only work if the CD player is stopped, or you can
switch it off altogether (see page 36).
Adjusting the sound
Volume is adjustable from zero (silence) to 36 (maximum
volume) using the volume + and – buttons on the remote.
You can also adjust the bass, treble, balance and subwoofer
level to get the sound you want. Start a disc playing before
working through the steps below so that you can hear the
effect of changes as you make them.
SOUND
SET
1 Press SOUND.
Press repeatedly to switch between:
BASS - TREBLE - BALANCE - WOOFER LEVEL
Stop on the one you want to adjust.
2 Press SET.
The display shows the current level.
3 Use the 4 and ¢ buttons to adjust the
level.
The display indicates the level as you change it. (The
subwoofer has just three settings: LOW, MEDIUM and
HIGH.)
4 When you're happy with the level, press SET
again.
Tip
In step 3, if more than 5 seconds goes by without you pressing
a button, the system goes ahead and sets the new level for you,
without you having to press SET (step 4).
Approximate tansmitter
range
Door open sensor