Filter
Top Products
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
# If you do not operate the audio functionwithin
about 30 seconds, the display is automatically re-
turned to thesource display.
Using balance adjustment
You can change the fader/balance setting so
that it can provide you an ideal listening envir-
onment in all occupied seats.
1 Press AUDIO to select FADER.
# If the balance setting has been previously ad-
justed, BALANCE will be displayed.
2 Press a or b to adjust front/rear speak-
er balance.
FADER FRONT 15 to FADER REAR 15 is dis-
played as the front/rear speaker balance
moves from front to rear.
# FADER 0 is the proper setting when only two
speakers are used.
# When the rear output setting is REAR SP S/W,
you cannot adjust front/rear speaker balance.
Refer to Setting the rear output and subwoofer
controller on page 24.
3 Press c or d to adjust left/right speaker
balance.
BALANCE LEFT 15 to BALANCE RIGHT 15 is
displayed as the left/right speaker balance
moves from left to right.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are six stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
POWERFUL Powerful
NATURAL Natural
VOCAL Vocal
CUSTOM Custom
FLAT Flat
SUPERBASS Super bass
! CUSTOM is an adjusted equalizer curve
that you create. If you make adjustments to
an equalizer curve, the equalizer curve set-
ting will be memorized in CUSTOM.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFUL—NATURAL—VOCAL—CUSTOM
—FLAT—SUPERBASS
Adjusting equalizer curves
You can adjust the currently selected equalizer
curve setting as desired. Adjusted equalizer
curve settings are memorized in CUSTOM.
1 Press AUDIO to select EQ.
2 Press c or d to select the equalizer
band to adjust.
EQ-LOW (low)—EQ-MID (mid)—EQ-HIGH
(high)
3 Press a or b to adjust the level of the
equalizer band.
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Note
If you make adjustments, CUSTOM curve is up-
dated.
Operating this unit
En
19
English
Section
02